Filter
Top Products
ENGINE 3-21
GENERATOR ROTOR AND STARTER DRIVEN GEAR
• Hold the generator rotor with the special tool.
09930-44520: Rotor holder
• Remove the generator rotor bolt.
• Install a bolt A of suitable size to the left end of crankshaft.
SUITABLE BOLT A [M12, length: 28 – 38 mm (1.1 – 1.5 in)]
• Remove the generator rotor 1 and starter driven gear 2 with
the special tool.
09930-34980: Rotor remover
WATER PUMP
• Remove the water hoses and water inlet connector 1.
• Remove the water pump 2.
WATER PUMP SERVICING (7-11)
28 – 38 mm (1.1 – 1.5 in)