Filter
Top Products
EXHAUST SYSTEM 6-7
EXCV CABLE REPLACEMENT
• Lift and support the fuel tank. (5-3)
• Check the EXCVA to adjustment position. (6-4)
• Disconnect the EXCV cables from the EXCVA pulley.
(6-4)
• Measure the thread length A before disconnecting the No.1
cable.
• Disconnect the EXCV cables 1 and 2 from the EXCV
pulley 3 and bracket 4.
NOTE:
The EXCV cables are identified by the letters and shape.
No.1 cable 1: 01H0CL
No.2 cable 2: 01H0OP
• Connect the EXCV cables (1 and 2) temporarily to the EXCV pulley.
• Turn the adjuster 5 in or out and adjust the thread length A becomes the measured value before dis-
connecting ther No.1 cable.
• Tighten the lock-nut 6.
• After adjusting the thread length A, adjust the inner cable length B becomes 41.0 – 42.0 mm (1.61 –
1.65 in) by turning the adjuster 8.
• Tighten the lock-nut 7.
• Turn in the No.2 cable adjuster 0 fully.
• Loosen the lock-nuts A and turn the No.2 cable adjuster B in or out until the inner cable length C
becomes 60.0 – 61.0 mm (2.36 – 2.40 in).
• After adjusting the inner cable length C, tighten the lock-nuts A.
If the EXCVA adjustment is necessary,refer to page
6-8 to -10 for EXCVA ADJUSTMENT setting procedure.
01H0CL
01H0OP