Filter
Top Products
3-16 ENGINE
CYLINDER HEAD
• Remove the thermostat cover 1.
• Remove the thermostat 2 and thermostat conector 3.
THERMOSTAT INSPECTION (7-9)
• Remove the ECT sensor 4.
ECT SENSOR INSPECTION (7-7)
• Remove the cylinder head bolts (M6) 5.
• Remove the O-rings 6.
• Remove the cylinder head bolts and washers.
NOTE:
When loosening the cylinder head bolts, loosen each bolt little
by little diagonally.
• Remove the cylinder head.
• Remove the dowel pins and gasket.
CLUTCH
• Remove the clutch cover 1 along with the CKP sensor 2.
• Remove the dowel pins and gasket.
CKP SENSOR INSPECTION (4-35)