Filter
Top Products
CHASSIS 8-53
SUSPENSION SETTING
After installing the rear suspension, adjust the spring pre-load
and damping force as follows.
SPRING PRE-LOAD ADJUSTMENT
The set length 176.4 mm (6.94 in) provides the maximum spring
pre-load.
The set length 186.4 mm (7.34 in) provides the minimum spring
pre-load.
STD length: 181.4 mm (7.14 in)
DAMPING FORCE ADJUSTMENT
Rebound side
Turn the damping force adjuster 1 clockwise fully. It is at stiffest
position and turn it out to standard setting position.
STD position: 1 3/4 turns out from stiffest position
[Fine-tune the adjuster by turning it slightly until two punch
marks align.]
Low speed Compression side
Turn the damping force adjuster 2 clockwise fully. It is at stiffest
position and turn it out to standard setting position.
STD position: 1 3/4 turns out from stiffest position
[Fine-tune the adjuster by turning it slightly until two punch
marks align.]
High speed Compression side
Turn the damping force adjuster 2 clockwise fully. It is at stiffest
position and turn it out to standard setting position.
STD position: 3 turns out from stiffest position
[
Standard suspension setting
REAR
Spring set length
Damping force adjuster
Rebound Compression
Solo and
dual riding
181.4 mm (7.14 in)
1 3/4 turns out from
stiffest position
Low speed side:
1 3/4 turns out from
stiffest position
High speed side:
3 turns out from stiff-
est position