Filter
Top Products
EXHAUST SYSTEM 6-5
• Hold the EXCVA pulley with an adjustable wrench, and
loosen the pulley mounting bolt.
• Remove the EXCVA pulley from the EXCVA body.
EXCVA PULLEY INSPECTION
• Inspect the EXCVA pulley groove for wear and damage.
• If any defects are found, replace the EXCVA pulley with a new
one.
EXCVA INSTALLATION
• Install the EXCVA pulley 1 to the shaft 2.
NOTE:
Align the shaft’s line
A
and cable slots
B
as shown.
• Hold the EXCVA pulley with an adjustable wrench, and then
tighten the EXCVA pulley mounting bolt to the specified
torque.
EXCVA pulley mounting bolt: 5 N·m (0.5 kgf-m, 3.5 lb-ft)
* When loosening or tightening the pulley bolt, be sure
to fix the pulley with an adjustable wrench, or EXCVA
may get damaged.
* Do not use the adjustable wrench to turn EXCVA pul-
ley so as not to cause damage to the internal gear of
EXCVA.
When loosening or tightening the pulley bolt, be sure
to fix the pulley with an adjustable wrench, or EXCVA
may get damaged.