Filter
Top Products
3-88 ENGINE
*1: Direction of outside *2: Paint
DRIVE PLATE:
a No. 2 Drive plate....... 1 pc. [Black paint/I.D. 111 mm (4.4 in)]
b No. 1 Drive plate....... 6 pcs. [Purple paint/I.D. 111 mm (4.4 in)]
c No. 3 Drive plate....... 1 pc. [NIL/I.D. 118 mm (4.6 in)]
NOTE:
No.3 drive plate can be distinguished by the inside diameter
(I.D.).
DRIVEN PLATE: (d + e = Total 7 pcs.)
d No. 1 Driven plate (Thickness): 2.6 mm (0.102 in).....5 – 7 pcs.
e No. 2 Driven plate (Thickness): 2.3 mm (0.091 in).....2 – 0 pcs.
• Install the pressure plate H.
NOTE:
When install the pressure plate, fit the convex part
D
of the
pressure plate onto the concave part
E
of the clutch sleeve hub.
• Install the clutch springs.
• Hold the clutch housing with the special tool.
09920-53740: Clutch sleeve hub holder
• Tighten the clutch spring set bolts to the specified torque.
Clutch spring set bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
NOTE:
* Tighten the clutch spring set bolts diagonally.
* After mounting the engine, adjust the push rod. (
2-16)
*1 *2
or
Be careful not to damage the clutch housing or clutch
plates.