Filter
Top Products
ELECTRICAL SYSTEM 9-19
TURN SIGNAL/SIDE-STAND RELAY
The turn signal/side-stand relay is composed of the turn signal
relay, side-stand relay and diode.
• Remove the front seat.(8-7)
• Disconnect the battery - lead wire from the battery.
• Remove the frame cover. (8-8)
• Remove the turn signal/side-stand relay 1.
SIDE-STAND RELAY INSPECTION
First check the insulation between D and E terminals with the
tester. Then apply 12 V to terminals D and C (+ to D and - to
C) and check the continuity between D and E. If there is no
continuity, replace the turn signal/side-stand relay with a new
one.
09900-25008: Multi-circuit tester set
Tester knob indication: Continuity test ()
DIODE INSPECTION
Measure the voltage between the terminals using the multi-cir-
cuit tester. Refer to the following table.
09900-25008: Multi-circuit tester set
Tester knob indication: Diode test ()
NOTE:
If the multi circuit tester reads 1.4 V and below when the tester
probes are not connected, replace its battery.
DIODE
SIDE-STAND RELAY
TURN
SIGNAL
RELAY
+ Probe of tester to:
- Probe of
tester to:
C, BA
C, B
1.4 V and more
(Tester’s battery voltage)
A 0.4 – 0.6 V