Filter
Top Products
3-82 ENGINE
• While holding the generator rotor with the special tool, tighten
the CKP sensor rotor/cam chain drive sprocket bolt.
09930-44520: Rotor holder
CKP sensor rotor/cam chain drive sprocket bolt:
54 N·m (5.4 kgf-m, 39.0 lb-ft)
STARTER IDLE GEAR
• Install the starter idle gear No. 2 1 and shaft 2.
• Apply SUZUKI BOND lightly to the mating surfaces A at the
parting line between the upper and lower crankcases.
99104-31140: SUZUKI BOND “1207B” (USA)
99000-31140: SUZUKI BOND “1207B” (Others)
• Install the dowel pin 3 and gasket 4.
• Install the generator cover.
NOTE:
* Fit the clamp to the generator cover bolt
B
.
Generator cover bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
Use a new gasket to prevent oil leakage.