Filter
Top Products
ENGINE 3-17
• Hold the clutch housing with the special tool.
09920-53740: Clutch sleeve hub holder
• Remove the clutch springs.
NOTE:
Loosen the clutch spring set bolts little by little and diagonally.
• Remove the pressure plate 3.
• Remove the clutch drive plates 4 and driven plates 5.
• Remove the clutch push piece 6, thrust washer 7 and bear-
ing 8.
• Remove the spring washer 9 and its seat 0.
• Remove the clutch push rod A.
NOTE:
If it is difficult to pull out the push rod
B
, use a magnetic hand or
a wire.
• Unlock the clutch sleeve hub nut.
Do not damage the clutch plates by the special tool.