Filter
Top Products
9-40 ELECTRICAL SYSTEM
BATTERY
SPECIFICATIONS
1 Upper cover breather 5 Terminal
2 Cathode plates 6 Safety valve
3 Stopper 7 Anode plates
4 Filter 8 Separator (Fiberglass plate)
INITIAL CHARGING
Filling electrolyte
• Remove the aluminum tape 1 sealing the battery electrolyte
filler holes A.
NOTE:
When filling electrolyte, the battery must be removed from the
vehicle and must be put on the level ground.
• Remove the caps 2.
NOTE:
* After filling the electrolyte completely, use the removed cap
2
as sealing caps of battery-filler holes.
* Do not remove or pierce the sealed areas
3
of the electrolyte
container.
• Insert the nozzles of the electrolyte container 4 into the bat-
tery’s electrolyte filler holes, holding the container firmly so
that it does not fall. Take precaution not to allow any of the
fluid to spill.
• Make sure air bubbles 5 are coming up each electrolyte con-
tainer, and leave in this position for about more than 20 min-
utes.
Type designation FTX9-BS
Capacity 12V,28.8kC (8Ah)/10 HR