Filter
Top Products
CHASSIS 8-25
• Insert the adjuster rod to the front fork cap bolt.
• Apply fork oil to the O-ring.
• Be sure to check or adjust the height D of the rebound damp-
ing force adjuster as follows.
H: 1.5 mm (0.05 in)
• Slowly turn the cap bolt completely by hand until the end of
the cap bolt seats on the inner-rod.
• Apply fork oil to the O-ring.
• Hold the cap bolt 2 and tighten the lock-nut 3 to the speci-
fied torque.
Inner rod lock-nut: 20 N·m (2.0 kgf-m, 14.5 lb-ft)
• Remove the special tools.
• Install the front fork cap bolt to the outer tube temporarily.
The removed O-ring must be replaced with a new one.
* The removed O-ring must be replaced with a new
one.
* Make sure that the rebound damping force adjuster
1 to the softest position before installing the cap
bolt.