Filter
Top Products
3-42 ENGINE
DISASSEMBLY
• With holding the rotor with the special tool remove the starter
clutch bolts.
09930-44520: Rotor holder
• Remove the one way clutch 1 and guide 2 from the rotor.
REASSEMBLY
• When fitting the one way clutch 1 to the guide 2, position
flange side A of one way clutch to the rotor side.
• When installing the starter clutch guide 2 to the rotor 3,
make sure that the flange B side faces outside.
• Degrease the securing bolts and bolt holes.
• Apply THREAD LOCK SUPER “1303” to the bolts and tighten
them to the specified torque while holding the rotor with the
special tool.
99000-32030: THREAD LOCK SUPER “1303”
Starter clutch securing bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
09930-44520: Rotor holder