Filter
Top Products
3-12 FUEL SYSTEM (DFI)
Specifications
Item Standard
Digital Fuel Injection System
Idle Speed 1 100 ±50 r/min (rpm)
Throttle Assy:
Type Four barrel type
Bore 34 mm (1.34 in.)
ECU (Electronic Control U nit):
Make Denso
Type
Digital memory type, with built in IC igniter, sealed with resin
Usable engine speed 100 ∼ 12 240 r/min (rpm)
Fuel Pressure (high pressure line):
Right after Ignition S W ON 310 kPa ( 3.2 kgf/cm², 46 psi) with fuel pump running
After 3 sec from Ignition SW ON 290 kPa (2.9 kgf/cm², 43 psi) with fuel pump stopped
With engine idling 310 kPa (3.2 kgf/cm², 46 psi) with fuel pum p running
Fuel Pump:
Type In-tank friction pump
Discharge 67 mL or more for 3 seconds
Fuel Injectors:
Type INP-285
Nozzle type One spray type with 4 holes
Resistance about 11.7 ∼ 12.3 Ω at 20°C (68°F)
Main Throttle Sensor: Non-adjustable and non-removable
Input voltage 4.75 ∼ 5.25 V DC between BL and BR/BK leads
Output voltage at idle throttle
opening
0.99 ∼ 1.03 V DC between Y/W and BR/BK leads
Output voltage at full throttle 4.19 ∼ 4.39 V DC between Y/W and BR/BK leads
opening
Resistance 4 ∼ 6kΩ
Inlet Air Pressure Sensor or
Atmospheric Pressure Sensor:
Input voltage 4.75 ∼ 5.25 V DC between BL and BR/BK leads
Output voltage 3.74 ∼ 4.26 V DC at standard atmospheric pressure (see
this text for details)
Inlet Air Temperature Sensor:
Resistance
1.6 ∼ 3.7 kΩ at 20°C (68°F)
0.24 ∼ 0.43 kΩ at 80°C (176°F)
Output voltage at ECU about 2.25 ∼ 2.50 V @20°C (68°F)
Water Temperature Sensor:
Resistance see Electrical System chapter
Output voltage at ECU about 2.80 ∼ 2.97 V @20°C (68°F)
Speed Sensor:
Input voltage at sensor about 9 ∼ 11 V DC at Ignition SW ON
Output voltage at sensor about 0.05 ∼ 0.07 V DC at Ignition SW ON and 0 km/h
Vehicle-down Sensor:
Detection method Magnetic flux detection method
Detection angle More than 60 ∼ 70° for each bank