Filter
Top Products
16-54 ELECTRICAL SYSTEM
Lighting System
This models adopt the daylight system and have a head-
light relay in the junction box. In these models, the head-
light does not go on when the ignition switch and the engine
stop switch are first turned on. The headlight comes on after
the starter button i s released and stays on until the ignition
switch is turned off. The headlight will go out momentarily
whenever the starter button is pressed and come back on
when the button is released.
Headlight B eam Horizontal Adjustment
•
Turn the horizontal adjuster [A] on the headlight with the
screwdriver in or out until the beam points straight ahead.
Headlight Beam Vertical Adjustment
•
Turn the vertical adjusters [A] on the headlight with the
screwdriver in or out to adjust the headlight vertically.
NOTE
○
On high beam, the brightest points should be slightly
below horizontal with the motorcycle on its wheels and
the rider seated. Adjust the headlight(s) to the proper
angle according to local regulations.
Headlight Bulb Replacement
•
Remove:
Headlight Connector [A]
Headlight Bulb Dust Cover [B]
•
Remove:
Hook [A]
Headlight Bulb [B]
CAUTION
When handling the quartz-halogen bulb, never
touch the glass portion with bare hands. Always
use a clean cloth. Oil contamination from hands or
dirty rags can reduce bulb life or cause the bulb to
explode.
NOTE
○
Clean off any contamination that inadvertently gets on
the bulb with alcohol or soap and water solution.
•
Replace the headlight bulb.