Filter
Top Products
2-26 PERIODIC MAINTENANCE
Periodic Maintenance Procedures
Tread Depth
Front:
Standard: 3.4 mm (0.13 in.)
Service Limit: 1 mm (0.04 in.)
1.6 mm (0.06 in.) (AT, CH, DE)
Rear:
Standard: 5.8 mm (0.23 in.)
Service Limit: 2 mm (0.08 in.)
(Up to 130 km/h (80 mph))
3 mm (0.12 in.)
(Over 130 km/h (80 mph))
WARNING
To ensure safe handling and stability, use only the
recommended standard tires for replacement, in-
flated to the standard pressure.
NOTE
○
Most countries may have their own regulations a mini-
mum tire tread depth: be sure to follow them.
○
Check and balance the wheel w hen a tire i s replaced
with a new one.
Air Pressure Inspection
•
Remove the air valve cap.
•
Measure the tire air pressure with an air pressure gauge
[A] when the tires are cold (that is, when the m otorcycle
has not been ridden more than a mile during the past 3
hours).
Adjust the tire air pressure according to the specifications
if necessary.
Air Pressure (when cold)
Front 250kPa(2.5kgf/cm²,36psi)
Rear
Up to 180 kg
(397 lb)
290kPa(2.9kgf/cm²,42psi)
•
Install the air valve cap certainly after air pressure inspec-
tion.
Torque - Air Valve Cap: 0.15 N·m (0.015 kgf·m, 1.3 in·lb)