Filter
Top Products
ENGINE TOP E ND 5-19
Cylinder Head
Cylinder Head Removal
•
Drain the coolant (see Cooling System chapter).
•
Remove:
Exhaust Pipes (see Exhaust Pipe Removal)
Coolant Drain Bolt [A] (cylinder)
•
Remove:
Cylinder Head Cover (see Cylinder Head Cover Re-
moval)
Camshaft Position S ensor (see Electrical System chap-
ter)
Camshafts (see Camshaft Removal)
Throttle Body (see Fuel System (DFI) chapter)
Water Hose
Upper Engine Mounting Bolts (both side) [A]
Front Camshaft Chain Guide
•
Remove the M6 cylinder head bolts [B], and then the M10
cylinder head bolts [A].
•
Take off the cylinder head.
Cylinder Head Installation
NOTE
○
The camshaft cap is machined with the cylinder head,
so if a new cylinder head is installed, use t he cap that
is supplied with the new head.
•
Install a new cylinder head gasket and dowel pins.
•
Apply molybdenum disulfide oil solution to both sides [A]
of the cylinder head bolt washers [B] and the thread of
head bolts [C].
•
Tighten the M10 cylinder head bolts following the tighten-
ing sequence [1 ∼ 10].
Torque - Cylinder Head Bolts (M10):
First 20 N·m (2.0 kgf·m, 14.5 ft·lb)
Final Used Bolts 49 N·m (5.0 kgf·m, 36 ft·lb)
New Bolts 54 N·m (5.5 kgf·m, 40 ft·lb)
•
Tighten the M6 cylinder head bolts [11 ∼ 12].
Torque - Cylinder Head Bolts (M6): 12 N·m (1.2 kgf·m, 104
in·lb)