Filter
Top Products
ENGINE REMOVAL/INSTALLATION 8-7
Engine Removal/Installation
•
Remove the middle and lower engine mounting nuts [A]
and bolts.
•
Remove:
Rear Engine Bracket Bolts [B]
Rear Engine Bracket [ C]
•
Using the nut wrench [A], loosen the locknut [B].
Special Tool - Engine Mount Nut Wrench: 5 7001–1450
•
Using t he Hexagon Wrench, turn the adjusting collar [A]
counter clockwise to mark the gap between the engine
and frame adjusting collar.
•
Remove the drive chain [A] from the output shaft [B].
•
Using the stand, take out the engine.
Engine Installation
•
Support the engine [A] with a suitable stand [B].
○
Put a plank onto the suitable stand for engine balance.
•
Screw the adjusting collar fully by hand.
•
Install the engine ground cable.
Torque - Engine Ground Cable Terminal Bolt: 9.8 N·m (1. 0
kgf·m, 87 in·lb)