Filter
Top Products
7-12 ENGINE LUBRICATION SYSTEM
Oil Pump
•
Install:
Pins [A]
Water Pump Body [B]
•
Install:
Impeller [A], Washer and Bolt [B]
•
Tighten:
Torque - Water Pump Impeller Bolt: 9.8 N·m (1.0 kgf·m, 87
in·lb)
•
Install:
Pins [C]
Water Pump Cover and Bolts
Torque - Water Pump Cover Bolts: 11 N·m (1.1 kgf·m, 95
in·lb)
•
Install:
Water Pipes [A]
•
Tighten:
Torque - Water Pipe Bolts [B]: 11 N·m (1.1 kgf·m, 95 in·lb)
Oil Pump Drive Gear Removal
•
Remove:
Clutch (see Clutch chapter)
Oil Pan (see Oil Pan Removal)
Circlip [A] and Washer
Oil Pump Drive Gear
Oil Pump Drive Gear Installation
•
Apply molybdenum disulfide oil solution to the journal por-
tions [A] on the oil pump gear shaft [B].
•
Install:
Washers [C]
•
Install the new circlip [D] into the groove of the oil pump
drive gear shaft.