Filter
Top Products
5-10 ENGINE TOP END
Clean Air System
Air Suction Valve Removal
•
Remove:
Fuel Tank (see Fuel System (DFI) chapter)
Connector [A] (from Clamp [B])
Air Suction Valve Cover Bolts [C] and Clamp
Air Suction Valve Cover [D]
Air Suction Valve
Air Suction Valve Installation
•
Install the air suction valve [A] so that its wider side [B] of
the reed valve case faces the front.
•
Tighten:
Torque - Air Suction Valve Cover Bolts: 9.8 N·m (1.0 kgf·m,
87 in·lb)
Air Suction Valve Inspection
•
Refer to the Engine Top End in the Periodic Maintenance
chapter.
Vacuum Switch Valve Removal
•
Remove:
Fuel Tank (see Fuel System (DFI) chapter)
Vacuum Switch Valve [A]
Vacuum Switch Valve Installation
•
Install t he vacuum switch valve so that the vacuum fitting
[A] faces left side.
•
Route the hoses correctly (see Appendix chapter).