Filter
Top Products
16-44 ELECTRICAL SYSTEM
Ignition System
WARNING
To avoid extremely high voltage shocks, do not
touch the spark plugs or tester connections.
•
Turn the ignition switch and the engine stop switch ON.
•
Pushing the starter button, turn the engine 4 ∼ 5 seconds
with the transmission in neutral to measure the primary
peak voltage.
•
Repeat the measurements 5 times for one stick coil.
Stick Coil Primary Peak Voltage
Standard: 88 V or more
•
Repeat the test for the other stick coil.
If the reading is less than the specified value, check the
following.
Stick Coils (see Stick Coil Inspection)
Crankshaft Sensor (see Crankshaft Sensor Inspection)
If the stick coils, and crankshaft sensor are normal, check
the ECU (see Fuel System (DFI) chapter).
Spark Plug Removal
•
Refer to the Electrical System in the Periodic Mainte-
nance chapter.
Spark Plug Insta llation
•
Refer to the Electrical System in the Periodic Mainte-
nance chapter.
Spark Plug Inspection
•
Refer to the Electrical System in the Periodic Mainte-
nance chapter.
Spark Plug Gap Inspection
•
Refer to the Electrical System in the Periodic Mainte-
nance chapter.