Filter
Top Products
2-28 PERIODIC MAINTENANCE
Periodic Maintenance Procedures
•
Bend the cotter pin [A] over the nut.
WARNING
If the rear axle nut is not securely tightened or the
cotter pin is not installed, an unsafe riding condi-
tion may result.
Drive Chain Wear Inspection
•
Remove:
Chain C over Screws [A]
Chain Cover [B]
Mud Guard [C] (see Frame chapter)
•
Rotate the rear wheel to inspect the drive chain for dam-
aged rollers, and loose pins and links.
If there is any irregularity, replace the drive chain.
Lubricate the drive chain if it appears dry.
•
Stretch the chain taut by hanging a 98 N (10 kg, 20 lb)
weight [A] on the chain.
•
Measure the length of 20 links [B] on the straight part [C] of
the chain from the pin center of the 1st pin to the pin center
of the 21st pin. Since the chain may wear unevenly, take
measurements at several places.
If any measurements exceed the service limit, replace the
chain. Also, replace the front and rear sprockets when the
drive chain is replaced.
Drive Chain 20-link Length
Standard: 317.5 ∼ 318.2 mm (12.50 ∼ 12.53 in.)
Service Limit: 323 mm (12.7 in.)
WARNING
If the drive chain w ear exceeds the service limit, re-
place the chain or an unsafe riding condition may
result. A chain that breaks or jumps off the sprock-
ets could snag on the engine sprocket or lock the
rear wheel, severely damaging the motorcycle and
causing it to go out of control.
For safely, use only the standard chain. It is an end-
less type and should not be cut for installation.
Standard Chain
Make: ENUMA
Type: EK520MVXL
Link: 112 Links