Filter
Top Products
ENGINE LUBRICATION SYSTEM 7-9
Oil Pan
Oil Pan Removal
•
Remove:
Engine Oil (drain, see Engine Lubrication System in the
Periodic Maintenance chapter)
Exhaust Pipe Assy and Muffler Body (see Engine Top
End chapter)
Oil Pan Bolts [A]
Oil Pan [B]
Oil P an Installation
•
Clean the oil screen [A].
•
Install the oil screen so that the crankcase rib [B] fits the
slot [C] of the oil screen.
•
Apply engine oil to the O -rings on the oil pipe.
If the oil pressure relief valve was removed, install it.
○
Apply a non-permanent locking agent to the threads of
the oil pressure relief valve, and tighten it.
CAUTION
Do not apply too much non-permanent locking
agent to the threads. This may block t he oil pas-
sage.
Torque - Oil Pressure Relief Valve: 15 N·m (1.5 kgf·m, 11
ft·lb)
•
Install the clamp [A] at an angle of within 45° [B] as shown.
•
Replace the oil pan gasket with a new one.
•
Tighten:
Torque - Oil Pan Bolts [C]: 11 N·m (1.1 kgf·m, 95 in·lb)