Filter
Top Products
FUEL SYSTEM (DFI) 3-83
Fuel Injectors
Injector Signal Test
•
Prepare two test light sets with male terminals as shown.
Rating of Bulb [A]: 12 V × 3 ∼ 3.4 W
Terminal Width [B]: 1.8 mm (0.071 in.)
Terminal Thickness [C]: 0.8 mm (0.031 in.)
CAUTION
Do not use larger terminals than specified above. A
larger terminal could damage the injector main har-
ness connector (female), leading to harness repair
or replacement.
Be sure to connect bulbs in series. The bulb works
as a current limiter to protect the solenoid in the
injector from excessive current.
•
Remove the fuel tank (see Fuel Tank Removal).
•
Remove connectors for injector [A].
•
Connect each test light set [B] to the injector sub harness
connector [C].
•
T urn the ignition switch ON.
•
While cranking the engine with the starter motor, watch
the test lights.
If the test lights flicker at regular intervals, the injector
circuit in the ECU , and the wiring are good. Perform the
“Injector Resistance Inspection”.
○
Injector signals can be also confirmed by connecting the
hand tester (× 10 V AC) instead of the test light set to
the injector main harness (female) connector. Crank the
engine with the starter motor, and check to see if the hand
oscillates at regular intervals.
Special Tool - Hand Tester: 57001–1394
If the test light doesn’t flicker (or the tester needle doesn’t
oscillates), check the wiring and connectors again. If the
wiring is good, check the injector voltage. If the wiring is
good, inspect the ECU f or its ground and power supply
(see ECU section).