Filter
Top Products
9-28 CRANKSHAFT/T RANSMISSION
Transmission
NOTE
○
When the toothed washers [28] [29] are assembled onto
the output shaft, note the following.
○
When the tangs [A] of the toothed washer [29] shall be
assembled, they should be installed into the notch [B]
of the toothed washer [28] (see Page 9–29).
•
Fit the steel balls into the 5th gear holes in the output
shaft, aligning three oil holes [D].
5th Gear [A]
Output Shaft [ B]
Steel Balls [C]
CAUTION
Do not apply grease to the balls to hold t hem in
place. This will cause the positive neutral finder
mechanism to malfunction.
○
After assembling the 5th gear with steel balls in place on
the output shaft, check the ball-locking effect that the 5th
gear doesn’t com e out of the output shaft when moving it
up and down by hand.
•
Check that each gear spins or slides freely on the trans-
mission shafts without binding after assembly.