Filter
Top Products
12-20 BRAKES
Brake Hose
Brake Hose Removal/Installation
CAUTION
Brake fluid quickly ruins painted or plastic sur-
faces; any spilled fluid should be completely wiped
up immediately with wet cloth.
•
When removing the brake hose, take care not to spill the
brake fluid on the painted or plastic parts.
•
When removing the brake hose, temporarily secure the
end of the brake hose to some high place to keep fluid
loss to a minimum.
•
There are washers on each side of the brake hose fitting.
Replace them with new ones when installing.
•
When installing the hoses, avoid sharp bending, kinking,
flattening or twisting, and route the hoses according to
Cable, Wire and Hose Routing section in General Infor-
mation chapter.
•
Tighten:
Torque - Brake Hose Banj o Bolts: 25 N·m (2.5 k gf·m, 18
ft·lb)
•
Bleed the brake line after installing the brake hose (see
Brakes in the Periodic Maintenance chapter).
Brake Hose Inspection
•
Refer to the Brakes in the Periodic Maintenance chapter.