Filter
Top Products
CRANKSHAFT/TRANSMISSION 9-27
Transmission
•
Remove the ball bearing [A] from each shafts.
Special Tools - Bearing Puller: 57001–135 [B]
Bearing Puller Adapter: 57001–317 [C]
•
Discard the bearing.
Transmission Shaft Assembly
•
Apply engine oil to the bushings, ball bearings and shafts.
•
Install the gear bushings [A] on the shaft with their holes
[B] aligned.
•
Replace any circlips removed with new ones.
•
Install the circlips [A] so that the opening [B] is aligned
withasplinegroove[C].
•
The drive shaft gears can be recognized by size: the gear
with the smallest diameter is 1st gear, and the largest one
is 6th gear. Be sure that all parts are put back in the cor-
rect sequence and all circlips and washers are properly in
place.
•
Install the 3rd/4th gear onto the drive shaft with their oil
holes aligned.
•
Install the 6th gear bushing onto the drive shaft with their
oil holes aligned.
•
The output shaft gears can be recognized by size: the
gear with the largest diameter is 1st gear, and the small-
est one is 6th gear. Be sure that all parts are put back
in the correct sequence and all circlips and washers are
properly in place.
•
Install the 5th and 6th gears onto the output shaft with
their oil holes aligned.
•
Install the 3rd/4th gear bushings onto the output shaft with
their oil holes aligned.