Filter
Top Products
16-28 ELECTRICAL SYSTEM
Battery
Terminal Voltage: 11.5 ∼ less than 12.6 V
Standard Charge
0.9 A × 5 ∼ 10 h
Quick Charge
4.0 A × 1.0 h
Battery Terminal Voltage (V) [A]
Charge Time (h) [B]
CAUTION
If possible, do not quick charge. If the quick charge
is done due to unavoidable circumstances, do stan-
dard charge later on.
Terminal Voltage : less than 11.5 V
Charging Method : 0.9 A × 20 h
NOTE
○
Increase the charging voltage to a maximum voltage of
25 V if the battery will not accept current initially. Charge
for no more than 5 minutes at the increased voltage then
check if the battery is drawing current. If the battery
will accept current decrease the voltage and charge by
the standard charging method described on the battery
case. If the battery w ill not accept current after 5 min-
utes, replace the battery.
Battery [A]
Battery Charger [B]
Standard Value [C]
Current starts to flow [D]
•
Determine battery condition after refreshing charge.
○
Determine the condition of the battery 30 minutes after
completion of the charge by measuring the terminal volt-
age according to the table below.
Criteria Judgement
12.6 V or higher Good
12.0 ∼ lower than 12.6 V Charge insufficient → Recharge
lower than 12.0 V Unserviceable → Replace