ELECTRICAL SYSTEM 16-29
Charging System
Alternator Cover Removal
•
Remove:
Left Frame Cover (see Frame chapter)
Clamp (open) [A]
Alternator Lead Connector [B]
•
Place a suitable container under the alternator cover [A],
and remove the cover bolts [B].
•
Pull the alternator cover outside.
Alternator C over Installation
•
Apply silicone sealant to the alternator lead grommet and
crankcase halves mating surface [A] on the front and rear
sides of the cover mount.
Sealant - Kawasaki Bond (Silicone Sealant): 56019– 120
•
Check that knock pins [B] are in place on the crankcase.
•
Install a new gasket and the alternator cover.
•
Tighten:
Torque - Alternator Cover Bolts: 11 N·m (1.1 kgf·m, 95 in·lb)
Stator Coil Removal
•
Remove:
Alternator Cover (see Alternator Cover Removal)
Holding Plate Bolt [A] and Plate
Alternator Lead Grommet [B]
Stator Coil Bolts [C]
•
Remove the stator coil [D] from the alternator cover.