Filter
Top Products
SUSPENSION 13-17
Swingarm
Swingarm Bearing Installation
•
Install the needle bearings so that the manufacturer ’s
marks face in.
•
Install the ball bearing so that the manufacturer’s m arks
faces out.
Special Tool - Bearing Driver Set: 57001–1129 [A]
Swingarm Bearing, Sleeve Inspection
CAUTION
Do not remove the bearings for inspection. Remove
may damage them.
•
Inspect the needle bearings [A] and ball bearing [B] in-
stalled in the swingarm.
○
The rollers and ball in bearing normally wear very little,
and wear is difficult to measure. Instead of measuring,
visually inspect the bearing for abrasion, discoloration, or
other damage.
If the needle bearings, ball bearing, and sleeve show any
sings of abnormal wear, discoloration, or damage. re-
place them as a set.
Chain Guide Inspection
•
Visually inspect the chain guide [A].
Replace the chain guide if it shows any signs of abnormal
wear or damage.