Filter
Top Products
16-50 ELECTRICAL SYSTEM
Electric Starter System
○
The brush plate [ A] and brushes come off with the right
-hand end cover [B].
•
Remove the terminal locknut [A] and terminal bolt [B], and
then remove the brush with the brush plate [C] from the
right-hand end cover.
Starter Motor Assembly
•
Install the brush plate and brushes [A], and then put the
armature [B] among the brushes.
•
Install the O-rings [A] as shown.
•
Align the notch [A] in the brush plate with the end cover
notch [B] and the mark [C] on the yoke.