Filter
Top Products
PERIODIC MAINTENANCE 2-19
Periodic M aintenance Procedures
•
Remove the fuel tank (see Fuel System (DFI) chapter).
•
Remove the fuel tank bracket bolts and bracket [A].
•
Remove:
Air Cleaner Duct Holder Screws [A]
•
Remove the air cleaner duct holder [B] backward.
•
Clean the element by tapping it lightly to loosen dust.
•
Blow away the remaining dust by applying compressed
air [A] from the outside to the inside (from the clean side
to the dirty side).
•
Visually inspect the element for no t ears or no breaks and
inspect the sponge gaskets [B] also.
If the element or gasket has any tears or breaks, replace
the element.
•
Install the element [A] with the flat side [B], facing for-
wards.
•
Fit the tongue [C] of the air cleaner duct holder into the
slot of the housing the air cleaner duct holder.
Torque - Air Clea ner Duct Holder Screws: 3.8 N·m (0.39
kgf·m, 34 in·lb)