Filter
Top Products
16-40 ELECTRICAL SYSTEM
Ignition System
Timing Rotor Removal
•
Remove the crankshaft sensor cover (see Crankshaft
Sensor Removal)
•
Remove the timing rotor [A].
○
Holding the timing rotor with the flywheel & pulley holder
[B] and remove the bolt [C].
Special Tool - Flywheel & Pulley Holder : 57001–1343
Timing Rotor Installation
•
Fit the rotor to the crankshaft.
•
Tighten the rotor bolt.
Torque - Timing Rotor Bolt : 39 N·m (4.0 kgf·m, 29 ft·lb)
•
Install the crankshaft sensor cover (see Crankshaft Sen-
sor Installation).
Camshaft Position S ensor Removal
•
Remove:
Fuel Tank (see Fuel System (DFI) chapter)
Camshaft Position Sensor Lead Connector [A] (discon-
nect)
○
Push the tongue [B] upside and take out the connector
from the bracket.
•
Remove:
Camshaft Position Sensor Bolt [A]
Camshaft Position Sensor [B]
Camshaft Position Sensor Installation
•
Apply grease or engine oil to the O-ring on the camshaft
position sensor.
•
Apply a non-permanent locking agent to the sensor bolt.
•
Tighten:
Torque - Camshaft Position Sensor Bolt: 12 N·m (1.2 kgf·m,
104 in·lb)