Open as PDF
2-6 FUEL SYSTEM
Throttle Grip and Cable
Cable Lubrica tion
Whenever the cable is removed, and in accordance with
the Periodic Maintenance Chart (see General Information
chapter), do the following.
Apply a thin coating of grease [A] to the cable upper end.
Lubricate the cable [A] with a penetrating rust inhibitor.
With the throttle cable [A] disconnected at both ends, the
cable should move freely within the cable housing.
If cable movement is not free after lubricating, if the cable
is frayed, or if the housing is kinked, replace the cable.