Kawasaki KX65 Motorcycle User Manual


 
14-6 APPE N DIX
General Lubrication
Lubrication (Periodic Maintenance )
Before lubricating each part, clean off any rusty spots with
rust remover and wipe off any grease, oil, dirt, or grime.
Lubricate the points listed below with indicated lubricant.
NOTE
Whenever the vehicle has been operated under
wet or rainy conditions, or especially after using a
high-pressure water spray, perform the general lubri-
cation.
Pivots: Lubricate with Motor Oil
Clutch Lever
Brake Lever
Kick Pedal
Shift Pedal
Drive Chain
Points: Lubricate with Grease [A].
Clutch Inner Cable Upper and Lower Ends
Throttle Inner Cable Upper Ends
Swingarm Pivot
Tie-Rod Pivot
Rocker arm Pivot
Steering Stem Bearing
Cables: Lubricate with Rust Inhibitor.
Throttle C ables
Clutch Cable [A]
With the cable disconnected at the both ends, the cable
[A] should move freely within the cable housing.
If cable movement is not free after lubricating, if the cable
is frayed, or if the cable housing is kinked, replace the
cable.