Kawasaki KX65 Motorcycle User Manual


 
COOLING SYSTEM 3-11
Water Pump
Press the ball bearing [A] into the hole until the bearing is
bottomed against the step [B].
Special Tools - Bearing Driver Set: 57001-1129
Apply plenty of high temperature grease to the oil seal lips
[D].
Set the oil seal (thick) so that dual lips side face outward
and set the oil seal (thin) so that a lip faces outward as
shown.
Press the oil seals [E] into the hole until the oil seal is
bottomed against the ball bearing or the seal.
Special Tools - Bearing Driver Set: 57001-1129 [C]
The end of the oil seal must be 0.5 ± 0.2 mm [F] lower
than the end of the right engine cover end [G].
Be sure the inner race of the ball bearing [A] turns
smoothly.