Kawasaki KX65 Motorcycle User Manual


 
ENGINE RIGHT SIDE 5-9
Right Engine Cover
Right Engine Cover Disassembly
Remove the right engine cover (see this chapter).
Pull out the clutch release shaft [A].
CAUTION
Do not remove the clutch release shaft unless it is
absolutely necessary. If removed, you must replace
the oil seal with a new ones.
Refer to the cooling system chapter for water pump seal
and water pump bearing removal.
Right Engine Cover Assembly
When the oil level gauge, needle bearings and oil seal
were removed, note the following .
Set the new oil level gauge [A] so that its metal portion [B]
faces outward and press in the gauge until it is bottomed.
Press the new lower needle bearing [C] until it is bot-
tomed. As for the installation direction, both sides are
available.
Set the new upper needle bearing [D] with the marked
side facing out and press bearing until it is bottomed.
Press the new oil seals [E] until they are bottomed and
apply a little high temperature grease [F] on the rips.
Refer to the Cooling System chapter for water pump seal
and water pump bearing installation.