Filter
Top Products
SUSPENSION 11-11
Front F ork
Front Fork Installation
•
If the fork leg was disassembled, check the fork oil level.
•
Install the fork so that the top end [A] of the inner tube is
10 mm up [B] with the upper surface [C] of the steering
stem head.
•
Install the fork so that the top end [A] of the inner tube is
20 mm up [B] with the upper surface [C] of the steering
stem head (KX65-A3 ∼).
•
Route the cables and hose according to the Cable, Wire
and Hose Routing section in the General Information
chapter.
•
Install the front wheel (see Wheels/Tires chapter).
•
Tighten the following:
Torque - Front Fork Clamp Bolts (Upper): 20 N·m (2.0
kgf·m, 14 ft·lb)
Front Fork Clamp Bolts (Lower): 29 N·m (3.0
kgf·m, 22 ft·lb)
Caliper Mounting Bolts: 25 N·m (2.5 kgf·m, 18 ft·lb)
•
Check the front brake operation after installation.
Front Fork Disassembly (each fork)
•
Remove the front fork (see this chapter).
•
Remove the top plug and the fork spring.
•
Drain the fork oil with the fork upside down (see Fork Oil
Change)
•
Hold the outer tube [A] in a vise.
•
Stop the cylinder [B] from turning by using the front fork
cylinder holder.
Special Tools - Fork Cylinder Holder Handle: 57001-183 [C]
Fork Cylinder Holder A dapter: 57001-1011
[D]
•
Unscrew the Allen bolt [E], then take the bolt and gasket
out of the bottom of the outer tube.
KX65-A3 ∼
•
Loosen the top plug.
•
Remove the front fork (see this chapter).
•
Hold the outer tube [A] in a vise.
•
Hold of the inner tube [B] and loosen the Allen bolt [C].
•
Remove the top plug, the fork spring seat and fork spring
(see Fork Oil Level Adjustment).
•
Drain the fork oil with the fork upside down (see Fork Oil
Change)
•
Take out the Allen bolt [C] and gasket.