Filter
Top Products
FINAL DRIVE 9-9
Sprockets
Rear Sprocket Warp Inspection
•
Using the jack, raise the rear wheel off the ground.
Special Tool - Jack: 57001-1238
•
Set a dial gauge [A] against the rear sprocket [B] near the
teeth as shown and rotate [C] the rear wheel to measure
the sprocket runout (warp). The difference between the
highest and lowest dial gauge readings is the amount of
runout (warp).
If the runout exceeds the service limit, replace the rear
sprocket.
Rear Sprocket Warp
Standard:
Under 0.4 mm
Service Limit:
0.5 mm