Open as PDF
5-6 ENGINE RIGHT SIDE
Free the clutch inner cable tip from the clutch release
Do not remove the clutch release shaft unless it is
absolutely necessary. If removed, release shaft oil
seal must be replaced with a new one.
Pull the clutch cable out of the frame.
Clutch Cable I nstallation
Run the clutch cable according to the Cable, Wire and
Hose Routing section of the General Information chapter.
Clutch Ca ble Lubrication and Inspection
Lubricate the clutch cable [A] using the pressure cable
lubber in accordance with the Periodic Maintenance
With the cable disconnected at both ends, the cable
should move freely within the cable housing (see Appen-
dix c hapter).