Filter
Top Products
13-10 ELECTRICAL SYSTEM
Flywheel Magneto
•
To check the stator coil resistance as follows.
○
Connect the hand tester to the terminals of the harness
connector [A] as shown in the table 2.
○
Note the readings.
Table 2 Stator Coil Resistance
Connections
Tester Range
Tester (+) Tester (–) to
Reading
×1Ω
Black/Red
Lead
Black/White
Lead
214 Ω ±20%
KX65A6F ∼:
Connections
Tester Range
Tester (+) Tester (–) to
Reading
×1Ω
Black/White
Lead
Black/Red
Lead
214 Ω ±20%
If there is more resistance than shown in the table, or no
hand tester reading (infinity) the stator has an open lead
and must be replaced. Much less than this resistance
means the stator is shorted, and must be replaced.
•
Using the highest resistance range of the hand tester,
measure the resistance between each leads and chas-
sis ground.
Any hand tester reading less than infinity (∞) indicates a
short, necessitating stator replacement.
If the stator coils have normal resistance, but the voltage
check showed the magneto to be defective; then the rotor
magnets have probably weakened, and the rotor must be
replaced.
Special Tool - Hand Tester: 57001-1394