Kawasaki KX65 Motorcycle User Manual


 
WHEELS/TIRES 8-5
Wheels (Rims)
Insert a new cotter pin [A].
NOTE
When inserting the cotter pin, if the slots in the nut do
not align with the cotter pin hole in the axle, tighten the
nut clockwise [B] up to next alignment.
It should be within 30 degree.
Loosen once and tighten again when the slot goes past
the nearest hole.
Bend the cotter pin [A] over the nut [B].
Remove the jack.
Check the front brake for good braking power and no
brake drag.
WARNING
Do not attempt to drive the motorcycle until a full
brake lever is obtained by pumping the brake lever
until the pads are against the disc. The brake will
not function on the first application of the lever if
this is not done.
Rear Wheel Removal
Using the jack under the frame so that the rear wheel is
raised off the ground.
Special Tool - Jack: 57001-1238
Remove the clip [A] from the master link using pliers, and
free the drive chain [B] from the rear sprocket.