Filter
Top Products
11-22 SUSPENSION
Tie-rod, Rocker Arm
Rocker Arm Installation
•
Apply plenty of grease to the inside of the rocker arm
holes, needle bearings, oil seals and grease seals out-
side of the sleeve.
•
Install the needle bearing [A], grease seals [B] and oil
seals [C] position as shown.
•
Tighten the following:
Torque - Rocker Arm Pivot Nut: 83 N·m (8.5 kgf·m, 61 ft·lb)
Rear Shock Absorber Mounting Nut (Lower): 34
N·m (3.5 kgf·m, 25 ft·lb)
Tie-rod Mounting Nuts: 59 N·m (6.0 kgf·m, 43 ft·lb)
Swingarm Pivot Shaft Nut: 69 N·m (7.0 kgf·m, 51
ft·lb)
Needle Bearing Inspection
If there is any doubt as to the condition of either needle
bearing, replace the bearing and sleeve as a set.