Kawasaki KX65 Motorcycle User Manual


 
6-4 ENGINE REMOVAL/INSTALLATION
Engine Removal/Installation
Engine In stallation
Install the engine on the frame.
Before tightening the engine mounting nuts, measure the
left and right clearance [A] between the bosses [B] of
crankcase and frame brackets [C] with thickness gauge.
Clearance: Under 0.3 mm
If the clearances are over the specified value, adjust them
by inserting the shim (Part No. 92180-1354) and tighten
the following nuts.
Torque - Engine Mounting Nuts:
25N·m(2.5kgm,18ft·lb)
29N·m(3.0kgf·m,21ft·lb):KX65-A3
Swing Arm Pivot Shaft Nut: 69 N·m (7.0 kgf·m, 51
ft·lb)
Shift Pedal Bolt: 8.8 N·m (0.90 kgf·m, 78 in·lb)
To route the leads, cables and hoses, refer to the General
Information chapter.
To install parts removed, refer to the appropriate chapters.
Fill the cooling system with coolant (see Cooling System
chapter).
Fill the engine with engine oil (see Engine Bottom
End/Transmission chapter).
Adjust:
Throttle Cable
Clutch Cable
Drive Chain
Rear Brake