Filter
Top Products
SUSPENSION 11 -19
Swingarm
Swingarm Remova l
•
Place the jack under the frame so that the rear wheel is
off the ground.
Special Tool - Jack: 57001-1238
•
Remove the rear wheel (see Wheels/Tires chapter).
•
Remove the brake pedal [A].
•
Remove the tie-rod rear mounting bolt [B].
CAUTION
When pulling out the mounting bolts, lift the rear
wheel slightly. Forcing or tapping on a bolt could
damage the bolt, sleeve, and bearing.
•
Pull out the swingarm pivot shaft [C], and remove the
swingarm [D].
•
Separate the chain guide and chain slipper from the
swingarm.
Swingarm Installation
•
Apply plenty of grease to the inside of the needle bear-
ings, sleeves, and oil seals caps.
•
Tighten the following:
Torque - Swingarm Pivot Shaft Nut: 69 N·m (7.0 kgf·m, 51
ft·lb)
Tie-rod Mounting Nut: 59 N·m (6.0 kgf·m, 43 ft·lb)
•
Refer to the Wheels/Tires, Final Drive, and Brakes chap-
ters for wheel installing.
Swingarm Bearing Removal
•
Remove:
Swingarm
Dust Seals [A]
Oil Seals [B]
Sleeves [C]
•
Remove the needle bearings [D] using the bearing re-
mover.
Special Tool - Oil Seal & Bearing Remover: 57001-1058