Filter
Top Products
SUSPENSION 11 -23
Uni-Trak Maintenance
Check the uni-trak component parts for wear periodically,
or whenever excessive play is suspected.
•
Using the jack under the frame, raise the rear wheel off
the ground.
Special Tool - Jack: 57001-1238
•
Push and pull on the swingarm [A], up and down, to check
for wear.
A small amount of play on the swingarm is normal and no
corrective action is needed. However, if excessive play is
felt, remove the uni-trak parts from the frame and check
for wear.
Rocker Arm Sleeve Wear Insp ection
•
Pull out the sleeves [A] of the rocker arm, and measure
the outside diameter of the sleeve.
If the sleeve is worn past the service limit, replace the
sleeve.
Sleeve Outside Diameter
Standard:
17.989 ∼ 18.000 mm
Service L im i t:
17.96 mm
Rocker Arm Mounting Bolt Bend Insp ection
A bent bolt causes vibration, poor handling, and instabil-
ity.
•
To measure the bolt runout, remove the bolt, place it
in V block, and set a dial gauge to the bolt at a point
halfway between the block. Turn [A] the bolt to measure
the runout. The amount of dial variation is the amount of
runout.
If runout exceeds the service limit, replace the bolt.
Bolt Runout
Standard:
Under 0.1 mm
Service L imit:
0.2 mm