Filter
Top Products
62
Reference Manual
00809-0100-4444, Rev AC
Section 4: Operation
January 2015
Operation
Pause totalizer
To pause the totalizer, press the DOWN arrow to display the totalizer screen and press the
RIGHT arrow to pause the totalizer. This will hold the current totalizer values on the screen for
reading or recording. The totalizer will continue to run even though the values are not changing.
To unpause the totalizer, press the RIGHT arrow again. The totalizer value will instantly
increment to the correct value and continuing running.
Stop totalizer
To stop the totalizer, press the DOWN arrow to display the totalizer screen and press “E” to end
totalization. The flashing symbol will no longer display in the lower right hand corner indicating
that the meter has stopped totalizing.
Reset totalizer
To reset the totalizer, press the DOWN arrow to display the totalizer screen and follow the
procedure above to stop totalization. Once totalization has stopped, press the RIGHT arrow key
to reset the NET total value to zero. To reset the GROSS, FORWARD, and REVERSE total values,
you must change the line size. See “Basic configuration” on page 36 for details on how to change
the line size.
4.2.5 Display lock
The 8732EM transmitter has display lock functionality to prevent unintentional configuration
changes. The display can be locked manually or configured to automatically lock after a set
period of time.
Manual display lock
To activate hold the UP arrow for 3 seconds and then following the on-screen instructions.
When the display lock is activated, a lock symbol will appear in the lower right hand corner of
the display. To deactivate the display lock, hold the UP arrow for 3 seconds and follow the
on-screen instructions. Once deactivated, the lock symbol will no longer appear in the lower
right hand corner of the display.
Auto display lock
1. Press the DOWN arrow key twice to access the menu. See Tab le 4- 2.
2. Using the arrow keys, select LOI config from the Detailed Setup menu.
3. Press DOWN arrow to highlight disp auto lock and press the RIGHT arrow to enter the
menu.
4. Press DOWN arrow to select the auto lock time.
5. When you reach the desired time, press “E” (the left arrow).
6. Set the loop to manual if necessary, and press “E” again.
After a moment, the LOI will display VALUE STORED SUCCESSFULLY and then display the
selected value.