Filter
Top Products
143
Reference Manual
00809-0100-4444, Rev AC
Section 8: Maintenance
January 2015
Maintenance
8.5.2 Replacing terminal block socket module
The terminal block socket module is shown in Figure 8-7. To gain access to the socket module,
remove the junction box from the sensor adapter.
Figure 8-7. Socket Module—Terminal Block
Removing terminal block socket module
1. Disconnect power to the transmitter and the remote cabling connected to the terminal
block.
2. Remove the junction box cover to gain access to the remote cabling.
3. To disconnect the terminal block from the junction box housing, remove the two
mounting screws and the two divider mounting screws (if applicable).
4. Pull up on the terminal block to expose the socket module base.
5. To remove the socket module, loosen the two mounting screws and pull up on the
socket module from the base.
6. When removing the socket module, do not pull on the wires. See Figure 8-5.