Filter
Top Products
Reference Manual
00809-0100-4444, Rev AC
Section 8: Maintenance
January 2015
137
Maintenance
Section 8 Maintenance
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 137
Safety information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 137
Installing a Local Operator Interface (LOI) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 138
Replacing 8732EM revision 4 electronics stack . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 139
Replacing socket module . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 141
Trims . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 144
Review . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 147
8.1 Introduction
This section covers basic transmitter maintenance. Instructions and procedures in this section
may require special precautions to ensure the safety of the personnel performing the
operations. Read the following safety messages before performing any operation described in
this section. Refer to these warnings when appropriate throughout this section.
8.2 Safety information
Failure to follow these maintenance guidelines could result in death or serious
injury.
Installation and servicing instructions should be performed by qualified personnel
only.
Do not perform any servicing other than that contained in the operating instructions.
Verify that the operating environment of the sensor and transmitter is consistent with
the appropriate hazardous area approval.
Do not connect a Rosemount 8732EM to a non-Rosemount sensor that is located in an
explosive atmosphere.
Mishandling products exposed to a hazardous substance may result in death or
serious injury.
If the product being returned was exposed to a hazardous substance as defined by
OSHA, a copy of the required Material Safety Data Sheet (MSDS) for each hazardous
substance identified must be included with the returned goods.