Filter
Top Products
100
Reference Manual
00809-0100-4444, Rev AC
Section 5: Advanced Configuration Functionality
January 2015
Advanced Configuration Functionality
Total limit hysteresis
Set the hysteresis band for the total limit to determine how quickly the transmitter comes out of
alert status.
Diagnostic status alert
The diagnostic status alert is used to turn on or off the diagnostics that will cause this alert to
activate.
ON - The diagnostic status alert will activate when a transmitter detects a diagnostic designated
as ON.
OFF - The diagnostic status alert will not activate when diagnostics designated as OFF are
detected.
Alerts for the following diagnostics can be turned ON or OFF:
Electronics Failure
Coil Open Circuit
Empty Pipe
Reverse Flow
Ground/Wiring Fault
High Process Noise
Electronics Temperature Out of Range
Electrode Coat Limit 1
Electrode Coat Limit 2
Continuous Meter Verification
5.3 Configure HART
The 8732EM has four HART variables available as outputs. The variables can be configured for
dynamic readings including flow, total, and diagnostic values. The HART output can also be
configured for burst mode or multi-drop communication if required.
LOI menu path
Detailed Setup, Output Config, Totalizer, Total Limit, Hysteresis
Traditional fast keys
1,4,2,3,5,5
Device dashboard
2,2,4,7
LOI menu path Detailed Setup, Output Config, Totalizer, Diagnostic Status Alert
Traditional fast keys 1,4,2,3,6
Device dashboard 2,2,4,8