Filter
Top Products
PERIODIC MAINT EN ANCE 2-43
Periodic Maintenan ce Procedures
Steering
Steering Inspection
•
Lif
t the front wheel off the ground using the jack.
Special Tool - Jack: 57001–1238
•
With the front wheel pointing straight ahead, alternately
tap each end of the handlebar. The front wheel should
swing fully left and right from the force of gravity until the
fork hits the stop.
If the wheel binds or catches before the stop, the steering
is too tight.
•
Feel for steering l ooseness by pushing and pulling the
forks.
If you feel looseness, the steering is too loose.
NOTE
○
The cables and wiring will have some effect on the mo-
tion of the fork which must be taken into account.
○
Be sure the wires and cables are properly routed.
○
The bearings must be in good condition and properly
lubricated in order for any test to be valid.
Steering Adjustment
Adjust the steering, if necessary.
•
Remove:
Windshield and Bracket (see Frame chapter)
Inner Cover (see Frame chapter)
Fairing and Bracket (see Frame chapter)
Handlebar (see Steering chapter)
•
Loosen the upper fork clamp bolts [A] on both side.
•
Remove the steering stem head bolt plug and the stem
head bolt [B].
•
Remove the steering stem head [C].
•
Bend the claw washer tabs [A].
•
Remove the steering stem locknut [B] and claw washer
[C].